StudentShare
Contact Us
Sign In / Sign Up for FREE
Search
Go to advanced search...

Electrical & electronic principles ( lap report ) AC power - Assignment Example

Cite this document
Summary
This was followed by connecting the inductance in series with a power resistor, low ohm and an ammeter alongside sketching an impedance triangle for the RL…
Download full paper File format: .doc, available for editing
GRAB THE BEST PAPER99% of users find it useful
Electrical & electronic principles ( lap report ) AC power
Read Text Preview

Extract of sample "Electrical & electronic principles ( lap report ) AC power"

Download file to see previous pages

Using the oscilloscope, the current and the voltage waveforms supplies were observed and determined alongside determining the lead or lag angle for the circuit. Various capacitor values were recorded with keen interest in observing their trend. The circuit was first connected with R1 s the coil resistance, with R2 as the low Ohm resistor already used. The component values were all recorded accordingly. Then using the oscilloscope, the current and the voltage supplies were observed, as well as used in determining the lag angle for the circuit.

Finally, the data for various capacitors were recorded. Whenever the capacitor is by-passed by an emitter, and capacitance of the coupled capacitor is large in regards to the AC frequency signal, the capacitors would be approximated as a circuit that is short (Alamo, Swirhum & Swanson, 2005). Whenever the input signal or voltage is increased the output voltage and the signal would be further vary around the dc bias point that has been established (Roulston, 2007). This effect would continue up to when the limiting condition of the voltage is reached.

For the current in the circuit, the limiting condition would be VCC/RC, at the end, considered to be high, and a zero at the end considered to be low of the swing. The voltage of the emitter collector and the supply limit reaches a limit when they have a zero and VCC. Additionally, the voltage output and the varying current around the point of bias give out ac power towards the load (Zeubman, 2008). The delivered ac power is made to go through the load referred to as RC. AC signal, on the other hand, makes the current in the base to be varied around the bias dc current and the current collector around its level of quiescent.

The input signal leads to ac signal voltage and the ac current. Increasing the input signal would increase the output swing until when the maximum

...Download file to see next pages Read More
Tags
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Electrical & electronic principles ( lap report ) AC power Assignment”, n.d.)
Electrical & electronic principles ( lap report ) AC power Assignment. Retrieved from https://studentshare.org/engineering-and-construction/1607244-electrical-electronic-principles-lap-report-ac-power
(Electrical & Electronic Principles ( Lap Report ) AC Power Assignment)
Electrical & Electronic Principles ( Lap Report ) AC Power Assignment. https://studentshare.org/engineering-and-construction/1607244-electrical-electronic-principles-lap-report-ac-power.
“Electrical & Electronic Principles ( Lap Report ) AC Power Assignment”, n.d. https://studentshare.org/engineering-and-construction/1607244-electrical-electronic-principles-lap-report-ac-power.
  • Cited: 0 times

CHECK THESE SAMPLES OF Electrical & electronic principles ( lap report ) AC power

Sensors and Control Systems (Electrical and Electronic Engineering)

It was discovered in 1879 and belongs to one of the galvanomagnetic phenomena in which the interaction between the magnetic field and the moving electrical charges results in the development of forces that alter the motion of the charge.... The energy types include electric energy, electromagnetic energy, mechanical energy, chemical energy and thermal energy....
12 Pages (3000 words) Lab Report

Electrical and Electronic Principles (A) UFMFP8-15-1

The purpose of this paper “Electrical and electronic principles (A) UFMFP8-15-1” is to experience and study the Kirchhoff's Voltage and Current Laws and to examine the given resistive circuits using the above laws and series parallel combinations of electronic circuits....  Electrical and electronic principles (A) UFMFP8-15-1 Aims and ObjectivesThe purpose of this lab is to experience and study the Kirchhoff's Voltage and Current Laws.... By the end of this lab, you should be able to analyze series parallel combinations of electronic circuits....
1 Pages (250 words) Lab Report

Electrical and Electronic principles

hen connected to the DC power source, the current flows through the circuit.... When the voltage on the terminals is of the capacitors is equal to the power supply voltage, the capacitor is fully charged.... When the circuit is disconnected from the power supply, the capacitor is said to be discharging through the resistors.... Draw the circuit shown in part 1 by replacing 5V DC power supply with a 10V AC 50Hz power supply and then perform the following: a) Analyse the circuits' behaviour by measuring the voltage across the resistor and capacitor when the switch is on charging position....
2 Pages (500 words) Lab Report

Electrical and Electronic principles

For the resistor both voltage and current are in same phase thus VR drawn on the same axis as current.... In inductor voltage leads current by 90 degrees… Voltage decays exponentially as the current flowing through the circuit grows exponentially to its maximum value.... For series of equal time periods the inductor is charged to its maximum value of which the current value will never reach Circuit behavior analysis The voltage across the inductor 8....
2 Pages (500 words) Lab Report

Electronic Laboratory Practise

Some waveforms of ac superimposed on DC were also shown using the oscilloscope....   After setting the oscilloscope time-base to 50, graphs were shown in the oscilloscope for ground, ac and DC.... Switching back to ac removes the DC component and show oscillations around the ground marker as illustrated in diagrams on the appendix.... In this report, a digital multimeter was used in taking current and resistance readings respectively....
2 Pages (500 words) Lab Report

Basic electric circuits and measurements

From this, the experiment is able to explain the relationship occurring between the… Intuitively, the nature of the experiment is guided by ohm's law which asserts that the amount of voltage flowing from one point to another end in a conductor is directly proportional to the current between the two points, while the Basic electric circuit and measurement The major objective of this lab report is to explore the aspect of electrical resistance of materials....
1 Pages (250 words) Lab Report

A Major Application of Series Resonance

his experiment was done with the aim of obtaining the resonant frequency and the half-power frequencies of a series RLC circuit.... The following paper entitled 'A Major Application of Series Resonance' discusses Series resonance is mainly applied in tuning devices such as in AM radio receivers to selectively respond to specific frequency while discriminating against other frequencies....
7 Pages (1750 words) Lab Report

Speed Control of DC and AC Machines

They have a flywheel diode to make power conversion a near-perfect process.... The paper "Speed Control of DC and ac Machines" highlights that ac machines are able to vary the speed with time increase.... They are affected by the ac signal frequency that is supplied to run the motor.... The experiment successfully illustrated how these machines are regulated, operated, and controlled to achieve a balance in the speeds; efficiency, cost, and speeds are required for the nature of the application desired for the ac motor....
11 Pages (2750 words) Lab Report
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.
Contact Us